Standoff With Light Model Installation
Step 1:
Figure out the selected location and the lower centerline of your address sign location and attach the provided installation template on your selcted location with Tape.
Step 2:
Using the provided 1/4" drill bit, drill into the back wall on the drill hole locations for the sign by about 1" depth and with the same 1/4" drill size, drill in a through hole on the wire hole location.
Step 3:
Remove the template and after cleaning the drilled holes from debris, fill out all sign holes with transparent silicon glue except the wire pass through hole.
Step 4:
Pass through the 4 ft wire for 12VDC LED power into the drilled wire hole using a wire fishing tool while holding the sign, then install the sign in the proper location by sliding in the back standoff screws into the drill holes and push them in smoothly until they reach to the stop sleeves.
Step 5:
Connect the other side of the passed through wire to the adapter connector by connecting RED wire to the Positive and BLACK wire to the Negative terminal. Then plug in the adapter into a 110VAC wall socket.
